Canon E3100 Ink Absorber Full Reset

When Canon E3100 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

During head cleaning, surplus ink is routed to internal absorber pads. Canon E3100 monitors this via a counter and can lock printing at a threshold.

This page is prepared for Canon E3100. Service mode instructions are shown only when a matching series procedure is known.

How the Error Appears

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

Finalize the Reset and Restore Printing

Once the counter is cleared, Canon E3100 should exit the locked state and printing should resume normally.

Warnings

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

Troubleshooting

• Repeat the service mode steps carefully (timing matters).
• Try a different USB cable/port if using PC software.
• Power-cycle the printer and try again.
• Close other Canon printer utilities while resetting.
• Use the correct Stop/Reset press count for your series.

Frequently Asked Questions