Epson RX690 Ink Pad Counter Reset Guide

Epson RX690 Waste Ink Counter Reset

When the Epson RX690 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson RX690 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson RX690 Waste Ink Counter

Most Epson RX690 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Step-by-Step: Epson RX690 Waste Counter Reset

  1. Schritt 1: Use a Windows PC (7–11) with Internet access. Connect Epson RX690 via USB (Wi-Fi reset is not supported).
  2. Schritt 2: Run Wic Reset Connect as Administrator and confirm Epson RX690 is detected.
  3. Schritt 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson RX690.
Buy Reset Key ⬇️ Download Wic Reset Connect Anweisungen

Most Epson RX690 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson RX690 – Waste Ink Counter Reset using Wic Reset Connect.

Warenkorb