Epson WorkForce 635 Waste Ink Counter Reset

When the Epson WorkForce 635 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson WorkForce 635 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson WorkForce 635 Ink Pad Counter Warning?

Most Epson WorkForce 635 waste ink counter locks are solved by a software counter reset. Wic Reset Connect giver en ligetil procedure.

Hvordan fejlen opstår

• Printeren nægter at udskrive, selv om der er blæk til rådighed
• Epson Status Monitor viser advarsel om vedligeholdelse
• Blinkende lys og blokerede jobs
• Enheden er låst, indtil nulstilling er udført

Step-by-Step: Epson WorkForce 635 Waste Counter Reset

1. Trin 1: Connect Epson WorkForce 635 to a Windows computer with a stable Internet connection using a USB cable.
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson WorkForce 635 appears in the device list.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson WorkForce 635.

Most Epson WorkForce 635 waste counter resets finish in ~1–2 minutes.

Før du begynder

• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Windows 7/8/10/11 PC
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Stabil internetforbindelse under nulstilling

Hvis printeren ikke registreres

• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Brug en direkte USB-forbindelse (undgå hubs).
• Luk Epson Status Monitor eller andre printerværktøjer.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Genstart printeren og pc'en, og prøv igen.