Fix Epson WorkForce 435 Service Required – Waste Counter Reset

Epson WorkForce 435 Waste Ink Counter Reset

The Epson WorkForce 435 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson WorkForce 435 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson WorkForce 435 Show ‘Service Required’?

与 Wic Reset Connect, you can reset the Epson WorkForce 435 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Three Steps to Restore Epson WorkForce 435 Printing

步骤 1： Prepare a Windows PC + USB cable and connect Epson WorkForce 435 directly. Keep Internet enabled for validation.
步骤 2： 运行 Wic Reset Connect as Administrator and confirm Epson WorkForce 435 is detected.
步骤 3： 粘贴重置密钥，点击重置, and after completion power-cycle Epson WorkForce 435.

购买重置密钥 ⬇️ 下载 Wic 重置连接说明

Most Epson WorkForce 435 waste counter resets finish in ~1–2 minutes.

故障排除

使用直接 USB 连接（避免使用集线器）。.
试试另一条 USB 电缆（有些电缆只能充电）。.
如果验证失败，则暂时禁用 VPN/代理。.
以管理员身份运行应用程序。.
关闭 Epson 状态监视器或其他打印机实用程序。.

常见问题

我需要服务中心吗？

通常不用于废墨计数器锁；重置通常就足够了。.

如果重置不起作用怎么办？

检查 USB 电缆/端口，以管理员身份运行，并关闭其他打印机实用程序。.

需要多长时间？

通常约 1-2 分钟。.

可以通过 Wi-Fi 重置吗？

重置需要通过 USB 连接到 Windows PC。.

Guide prepared for Epson WorkForce 435 – Waste Ink Counter Reset using Wic Reset Connect.