Model-specific reset guide
Canon G3900 Ink Absorber Full Reset
When Canon G3900 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
The waste ink counter inside Canon G3900
Cleaning operations send unused ink into absorber pads inside the printer. Canon G3900 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon G3900. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G3900
- Turn the printer off.
- Nhấn và giữ Dừng/Đặt lại.
- Trong khi giữ nút Stop/Reset, nhấn và giữ. Công suất.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 lần.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G3900
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G3900 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G3900 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon G3900 directly to the computer and try another data-capable USB cable or port.
Canon G3900 reset FAQ
Tôi nên nhấn nút Stop/Reset bao nhiêu lần?
For Canon G3900, use 5 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon G3900 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon G3900
Complete the Canon G3900 absorber counter reset in a few carefully prepared steps.