Fix Epson DX6000 Service Required – Waste Counter Reset

Epson DX6000 Waste Ink Counter Reset

When the Epson DX6000 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson DX6000 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson DX6000 Show ‘Service Required’?

Most Epson DX6000 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson DX6000 Waste Counter Reset

  1. Крок 1: Connect Epson DX6000 to a Windows computer with a stable Internet connection using a USB cable.
  2. Крок 2: Start Wic Reset Connect in Administrator mode and wait until Epson DX6000 appears in the device list.
  3. Крок 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson DX6000.
Buy Reset Key ⬇️ Download Wic Reset Connect Інструкції

Most Epson DX6000 waste counter resets finish in ~1–2 minutes.

System Requirements

  • USB connection required (Wi-Fi reset not supported)
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson DX6000 – Waste Ink Counter Reset using Wic Reset Connect.

Кошик для покупок