特定型号重置指南
Epson DX6000 Reset Waste Ink Counter
When Epson DX6000 reports that an ink pad needs service, restarting the printer alone normally does not clear the lock. A compatible reset procedure is required.
The counter behind the Epson DX6000 warning
Every cleaning cycle sends a small amount of ink to the waste ink system. Epson DX6000 adds that activity to its counter and displays a maintenance warning when the programmed threshold is reached.
Wic Reset Connect 旨在重置兼容的计数器 Epson DX6000. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson DX6000
先完成以下连接检查，然后运行重置程序；在此过程中不要打开其他打印机程序。.
-
安装原始驱动程序
Install the official Epson driver for DX6000 and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson DX6000 to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson DX6000.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson DX6000 is not detected
- 清除暂停的打印任务；如果其他程序占用了 USB 连接，请同时重新启动打印机和 Windows。.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- 以管理员身份运行 Wic Reset Connect，并在整个验证过程中保持互联网连接处于活动状态。.
- Install the original Epson driver for DX6000; a generic Windows driver may not expose the required communication interface.
Epson DX6000 reset FAQ
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.
如果第一次重置尝试失败怎么办？
请先解决驱动程序或 USB 通信问题。如果密钥已被使用，请使用新密钥生成器或联系支持人员。.
Can I reset Epson DX6000 over Wi-Fi?
不能。Wic Reset Connect 需要通过 USB 直接连接到 Windows 计算机。.