Epson L376 Ink Pad Counter Reset Guide

Epson L376 Waste Ink Counter Reset

When the Epson L376 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L376 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L376 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson L376 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson L376 Waste Ink Counter in 3 Steps

  1. Steg 1: Prepare a Windows PC + USB cable and connect Epson L376 directly. Keep Internet enabled for validation.
  2. Steg 2: Start Wic Reset Connect in Administrator mode and wait until Epson L376 appears in the device list.
  3. Steg 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L376.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruktioner

Most Epson L376 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Use a direct USB connection (avoid hubs).
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson L376 – Waste Ink Counter Reset using Wic Reset Connect.

Kundvagn