Epson L376 Waste Ink Counter Reset

When the Epson L376 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L376 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L376 Stops Printing (Waste Counter Limit)

Med Wic Reset Connect, you can reset the Epson L376 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typiske tegn

• Printeren nægter at udskrive, selv om der er blæk til rådighed
• Epson Status Monitor viser advarsel om vedligeholdelse
• Blinkende lys og blokerede jobs
• Enheden er låst, indtil nulstilling er udført

Reset Epson L376 Waste Ink Counter in 3 Steps

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson L376 directly. Keep Internet enabled for validation.
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson L376 appears in the device list.
3. Trin 3: Indtast din nulstillingsnøgle, og tryk på Nulstil. Wait ~1–2 minutes, then restart Epson L376.

Most Epson L376 waste counter resets finish in ~1–2 minutes.

Almindelige rettelser

• Brug en direkte USB-forbindelse (undgå hubs).
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).
• Luk Epson Status Monitor eller andre printerværktøjer.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Genstart printeren og pc'en, og prøv igen.

OFTE STILLEDE SPØRGSMÅL