Model-specific reset guide
Canon MG7140 Ink Absorber Full Reset
An absorber warning on Canon MG7140 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
The waste ink counter inside Canon MG7140
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG7140. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG7140
- Turn the printer off.
- Tryck och håll in Stopp/återställning.
- Medan du håller Stop/Reset, tryck och håll in Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 gånger.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG7140
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG7140 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG7140 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MG7140 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon MG7140 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Hur många gånger ska jag trycka på Stop/Reset?
For Canon MG7140, use 6 Stop/Reset presses in the sequence shown on this page.
Restore Canon MG7140
Complete the Canon MG7140 absorber counter reset in a few carefully prepared steps.