Canon MG7140 Ink Absorber Full Reset

When Canon MG7140 triggers an ink absorber full condition, the printer may block printing as a protective measure. The solution is typically a waste ink counter reset.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MG7140. Service mode instructions are shown only when a matching series procedure is known.

How to Enter Service Mode on Canon MG7140

To access maintenance functions, Canon MG7140 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 6 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Need a reset solution?

For best results, avoid rushing button presses—consistent timing matters.

FAQ