Fix Epson TX400 Service Required – Waste Counter Reset

Epson TX400 Waste Ink Counter Reset

When the Epson TX400 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX400 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson TX400 Stops Printing (Waste Counter Limit)

Most Epson TX400 waste ink counter locks are solved by a software counter reset. Wic Reset Connect omogoča enostaven postopek.

Kako se pojavi napaka

Tiskalnik noče tiskati, čeprav je črnilo na voljo
Epson Status Monitor prikazuje opozorilo o vzdrževanju
Utripajoče luči in blokirana delovna mesta
Naprava je zaklenjena, dokler se ne izvede ponastavitev

Reset Epson TX400 Waste Ink Counter in 3 Steps

1. korak: Prepare a Windows PC + USB cable and connect Epson TX400 directly. Keep Internet enabled for validation.
2. korak: Začetek Wic Reset Connect in Administrator mode and wait until Epson TX400 appears in the device list.
3. korak: Prilepite ključ za ponastavitev, kliknite Ponastavitev, and after completion power-cycle Epson TX400.

Nakup ključa za ponastavitev ⬇️ Prenos Wic Ponastavitev povezave Navodila

Most Epson TX400 waste counter resets finish in ~1–2 minutes.

POGOSTA VPRAŠANJA

Koliko časa traja?

Običajno približno 1-2 minuti.

Kaj če ponastavitev ne deluje?

Preverite kabel/port USB, zaženite ga kot upravitelj in zaprite druge pripomočke za tiskalnik.

Ali lahko ponastavitev izvedem prek omrežja Wi-Fi?

Ne. Ponastavitev zahteva povezavo USB z računalnikom Windows.

Ali potrebujem servisni center?

Običajno ne za zaklep števca za odpadno črnilo; ponavadi zadostuje ponastavitev.

Guide prepared for Epson TX400 – Waste Ink Counter Reset using Wic Reset Connect.