Epson ME-330 Waste Ink Counter Reset

Epson ME-330 Waste Ink Counter Reset

The Epson ME-330 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ME-330 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson ME-330 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson ME-330 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Reset Epson ME-330 Waste Ink Counter in 3 Steps

  1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson ME-330 via USB (Wi-Fi reset is not supported).
  2. Krok 2: Run Wic Reset Connect as Administrator and confirm Epson ME-330 is detected.
  3. Krok 3: Paste the reset key, click Reset, and after completion power-cycle Epson ME-330.
Buy Reset Key ⬇️ Download Wic Reset Connect Pokyny

Most Epson ME-330 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ME-330 – Waste Ink Counter Reset using Wic Reset Connect.

Nákupný košík