Epson Artisan 800 Waste Ink Counter Reset

Epson Artisan 800 Waste Ink Counter Reset

When the Epson Artisan 800 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson Artisan 800 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson Artisan 800 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson Artisan 800 waste counter reset in minutes.

Three Steps to Restore Epson Artisan 800 Printing

  1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson Artisan 800 via USB (Wi-Fi reset is not supported).
  2. Krok 2: Start Wic Reset Connect in Administrator mode and wait until Epson Artisan 800 appears in the device list.
  3. Krok 3: Use the key to reset the counter, wait for completion, then restart Epson Artisan 800 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Pokyny

Most Epson Artisan 800 waste counter resets finish in ~1–2 minutes.

What You Need

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.
  • Use a direct USB connection (avoid hubs).

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson Artisan 800 – Waste Ink Counter Reset using Wic Reset Connect.

Nákupný košík