Model-specific reset guide
Canon MG5740 Ink Absorber Full Reset
Canon MG5740 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
What stops Canon MG5740 from printing
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG5740. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG5740
- Turn the printer off.
- Stlačte a podržte tlačidlo Zastavenie/resetovanie.
- Počas držania tlačidla Stop/Reset stlačte a podržte Napájanie.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6-krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG5740
The counter reset normally takes only a few minutes after Canon MG5740 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG5740 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG5740 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon MG5740 directly to the computer and try another data-capable USB cable or port.
Canon MG5740 reset FAQ
Koľkokrát mám stlačiť tlačidlo Stop/Reset?
For Canon MG5740, use 6 Stop/Reset presses in the sequence shown on this page.
Does Canon MG5740 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon MG5740
Follow the verified steps for Canon MG5740, then restart the printer and return to normal operation.