Model-specific reset guide
Canon MG3100 Ink Absorber Full Reset
The waste ink system in Canon MG3100 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
What stops Canon MG3100 from printing
The absorber pads collect ink generated during print-head cleaning. Canon MG3100 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3100. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3100
- Turn the printer off.
- Stlačte a podržte tlačidlo Zastavenie/resetovanie.
- Počas držania tlačidla Stop/Reset stlačte a podržte Napájanie.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6-krát.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3100
The counter reset normally takes only a few minutes after Canon MG3100 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3100 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3100 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
Canon MG3100 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Koľkokrát mám stlačiť tlačidlo Stop/Reset?
For Canon MG3100, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MG3100
Complete the Canon MG3100 absorber counter reset in a few carefully prepared steps.