Epson NX330 Waste Ink Counter Reset

If your Epson NX330 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson NX330 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson NX330 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson NX330 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson NX330 Printing

1. Pasul 1: Use a Windows PC (7–11) with Internet access. Connect Epson NX330 via USB (Wi-Fi reset is not supported).
2. Pasul 2: Run Wic Reset Connect as Administrator and confirm Epson NX330 is detected.
3. Pasul 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson NX330.

Most Epson NX330 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.