Epson TX200 Ink Pad Counter Reset Guide

Epson TX200 Waste Ink Counter Reset

If your Epson TX200 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson TX200 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson TX200 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson TX200 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Epson TX200 Ink Pad Counter Reset – Quick Steps

  1. Passo 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX200 via USB (Wi-Fi reset is not supported).
  2. Passo 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX200.
  3. Etapa 3: Use the key to reset the counter, wait for completion, then restart Epson TX200 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruções

Most Epson TX200 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Run the app as Administrator.
  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson TX200 – Waste Ink Counter Reset using Wic Reset Connect.

Carrinho de compras