Epson TX130 Waste Ink Counter Reset

The Epson TX130 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson TX130 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson TX130 Waste Ink Counter

Most Epson TX130 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson TX130 Waste Counter Reset

1. Passo 1: Connect Epson TX130 to a Windows computer with a stable Internet connection using a USB cable.
2. Passo 2: Run Wic Reset Connect as Administrator and confirm Epson TX130 is detected.
3. Etapa 3: Use the key to reset the counter, wait for completion, then restart Epson TX130 to finalize.

Most Epson TX130 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.