How to Reset Epson ET-1114 Waste Ink Counter

Epson ET-1114 Waste Ink Counter Reset

The Epson ET-1114 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson ET-1114 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson ET-1114 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-1114 waste counter reset in minutes.

Reset Epson ET-1114 Waste Ink Counter in 3 Steps

  1. Passo 1: Prepare a Windows PC + USB cable and connect Epson ET-1114 directly. Keep Internet enabled for validation.
  2. Passo 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-1114.
  3. Etapa 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-1114.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruções

Most Epson ET-1114 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

If the Printer Is Not Detected

  • Restart printer and PC, then try again.
  • Close Epson Status Monitor or other printer utilities.
  • Try another USB cable (some cables are charge-only).
  • Temporarily disable VPN/proxy if validation fails.
  • Use a direct USB connection (avoid hubs).

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-1114 – Waste Ink Counter Reset using Wic Reset Connect.

Carrinho de compras