Model-specific reset guide
Canon TS6010 Ink Absorber Full Reset
When Canon TS6010 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
Why Canon TS6010 reports an absorber error
Canon TS6010 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon TS6010. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS6010
- Turn the printer off.
- Premir e manter premido Parar/Reiniciar.
- Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 vezes.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS6010
The counter reset normally takes only a few minutes after Canon TS6010 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS6010 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS6010 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS6010 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Quantas vezes devo premir Stop/Reset?
For Canon TS6010, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TS6010
Prepare Canon TS6010, enter service mode and complete the reset with a valid Wic Reset Connect key.