Model-specific reset guide

Canon TS3550i Ink Absorber Full Reset

The waste ink system in Canon TS3550i collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.

Tecla de reinicialização$8,00
Instant email deliverySuporte técnico incluídoReplacement key after a failed reset
The problem

The waste ink counter inside Canon TS3550i

An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.

Wic Reset Connect is designed to reset the compatible counter in Canon TS3550i. The physical waste ink system should still be inspected and maintained when necessary.

Required for Canon

How to enter service mode on Canon TS3550i

  1. Turn the printer off.
  2. Premir e manter premido Parar/Reiniciar.
  3. Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
  4. Release Stop/Reset but keep holding Power.
  5. Press and release Stop/Reset 5 vezes.
  6. Wait briefly, then release Power. The power indicator should remain steadily lit.
5Stop/Reset pressesSee all methods
Windows 7–11PC or laptop
Direct USBNo Wi-Fi or hub
InternetFor key validation
Tecla de reinicializaçãoFor this operation
Step by step

Reset the counter in Canon TS3550i

Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.

  1. Prepare the printer

    Resolve other errors, confirm a steady power light and enter service mode using the sequence above.

  2. Connect directly by USB

    Connect Canon TS3550i to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.

  3. Start Wic Reset Connect

    Run the program as Administrator and wait until the Canon service-mode device is detected.

  4. Enter the key and reset

    Enter the purchased key, select Reset and keep the printer connected until confirmation appears.

Finish correctly: Once Wic Reset Connect reports success, turn Canon TS3550i off and on, then send a small test page.
If Canon TS3550i is not detected
  • Connect Canon TS3550i directly to the computer and try another data-capable USB cable or port.
  • If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
  • Run Wic Reset Connect as Administrator and keep internet access active for key validation.
  • If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.

Open full instructions

Common questions

Canon TS3550i reset FAQ

Quantas vezes devo premir Stop/Reset?

For Canon TS3550i, use 5 Stop/Reset presses in the sequence shown on this page.

Can I perform the reset over Wi-Fi?

No. Use a direct USB connection between the printer and a Windows computer.

What if my reset key was used during a failed attempt?

Correct the cause first, then use the new-key generator or contact support for assistance.

Reset with confidence

Restore Canon TS3550i

Follow the verified steps for Canon TS3550i, then restart the printer and return to normal operation.

Reset key: $8,00
Shopping Cart
Selecione a sua moeda