Model-specific reset guide
Canon MG8100 Ink Absorber Full Reset
Canon MG8100 can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
Why Canon MG8100 reports an absorber error
Canon MG8100 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG8100. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG8100
- Turn the printer off.
- Premir e manter premido Parar/Reiniciar.
- Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 vezes.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG8100
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG8100 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG8100 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon MG8100 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
Canon MG8100 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Does Canon MG8100 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MG8100
Complete the Canon MG8100 absorber counter reset in a few carefully prepared steps.