Model-specific reset guide
Canon MG7740 Ink Absorber Full Reset
Canon MG7740 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What the Canon MG7740 service message means
The absorber pads collect ink generated during print-head cleaning. Canon MG7740 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon MG7740. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG7740
- Turn the printer off.
- Premir e manter premido Parar/Reiniciar.
- Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 vezes.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG7740
The counter reset normally takes only a few minutes after Canon MG7740 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG7740 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG7740 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon MG7740 directly to the computer and try another data-capable USB cable or port.
Canon MG7740 reset FAQ
Does Canon MG7740 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Quantas vezes devo premir Stop/Reset?
For Canon MG7740, use 6 Stop/Reset presses in the sequence shown on this page.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MG7740
Complete the Canon MG7740 absorber counter reset in a few carefully prepared steps.