Model-specific reset guide
Canon MG3570 Ink Absorber Full Reset
The waste ink system in Canon MG3570 collects ink used during cleaning cycles. Once the estimated limit is reached, service mode and a compatible counter reset may be required.
Why Canon MG3570 reports an absorber error
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG3570. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG3570
- Turn the printer off.
- Premir e manter premido Parar/Reiniciar.
- Enquanto mantém premido Stop/Reset, prima e mantenha premido Potência.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 vezes.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG3570
The counter reset normally takes only a few minutes after Canon MG3570 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG3570 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG3570 is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon MG3570 directly to the computer and try another data-capable USB cable or port.
Canon MG3570 reset FAQ
Does Canon MG3570 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Quantas vezes devo premir Stop/Reset?
For Canon MG3570, use 6 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon MG3570
Complete the Canon MG3570 absorber counter reset in a few carefully prepared steps.