Model-specific reset guide
Canon TS9060 Ink Absorber Full Reset
Canon TS9060 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon TS9060 reports an absorber error
Waste ink is routed away from the print head and retained inside the printer. The firmware in Canon TS9060 calculates usage and may stop new jobs to reduce overflow risk.
Wic Reset Connect is designed to reset the compatible counter in Canon TS9060. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS9060
- Turn the printer off.
- Naciśnij i przytrzymaj Stop/Reset.
- Przytrzymując przycisk Stop/Reset, naciśnij i przytrzymaj przycisk Moc.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 razy.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS9060
The counter reset normally takes only a few minutes after Canon TS9060 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS9060 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS9060 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon TS9060 directly to the computer and try another data-capable USB cable or port.
Canon TS9060 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Ile razy należy nacisnąć Stop/Reset?
For Canon TS9060, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon TS9060
Wic Reset Connect combines a guided reset with support if Canon TS9060 does not respond as expected.