Model-specific reset guide
Canon TS6280 Ink Absorber Full Reset
If Canon TS6280 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
Why Canon TS6280 reports an absorber error
The absorber pads collect ink generated during print-head cleaning. Canon TS6280 tracks those maintenance cycles in memory rather than measuring the pads directly.
Wic Reset Connect is designed to reset the compatible counter in Canon TS6280. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS6280
- Turn the printer off.
- Naciśnij i przytrzymaj Stop/Reset.
- Przytrzymując przycisk Stop/Reset, naciśnij i przytrzymaj przycisk Moc.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 razy.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS6280
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS6280 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS6280 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon TS6280 reset FAQ
Ile razy należy nacisnąć Stop/Reset?
For Canon TS6280, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS6280
Ready to reset Canon TS6280? Verify the power light, USB connection and service-mode state before continuing.