Model-specific reset guide
Canon Pro9500ii Ink Absorber Full Reset
Canon Pro9500ii can stop printing when its internal ink absorber counter reaches a programmed threshold. Follow the model-specific preparation below before using Wic Reset Connect.
Understanding the Canon Pro9500ii ink absorber warning
Cleaning operations send unused ink into absorber pads inside the printer. Canon Pro9500ii estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon Pro9500ii. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon Pro9500ii
- Turn the printer off.
- Naciśnij i przytrzymaj Stop/Reset.
- Przytrzymując przycisk Stop/Reset, naciśnij i przytrzymaj przycisk Moc.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 razy.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon Pro9500ii
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon Pro9500ii to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon Pro9500ii is not detected
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon Pro9500ii reset FAQ
Does Canon Pro9500ii require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Ile razy należy nacisnąć Stop/Reset?
For Canon Pro9500ii, use 6 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon Pro9500ii
Ready to reset Canon Pro9500ii? Verify the power light, USB connection and service-mode state before continuing.