Model-specific reset guide
Canon G6020 Ink Absorber Full Reset
Canon G6020 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Before resetting Canon G6020
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon G6020. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G6020
- Turn the printer off.
- Naciśnij i przytrzymaj Stop/Reset.
- Przytrzymując przycisk Stop/Reset, naciśnij i przytrzymaj przycisk Moc.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 razy.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G6020
First make sure the power indicator is steady and no cartridge or mechanical error is active. Then prepare the Windows computer and direct USB connection.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G6020 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G6020 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Connect Canon G6020 directly to the computer and try another data-capable USB cable or port.
Canon G6020 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Ile razy należy nacisnąć Stop/Reset?
For Canon G6020, use 5 Stop/Reset presses in the sequence shown on this page.
Does Canon G6020 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon G6020
Follow the verified steps for Canon G6020, then restart the printer and return to normal operation.