Epson XP-301 Waste Ink Counter Reset

The Epson XP-301 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

A waste ink counter in the Epson XP-301 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson XP-301 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-301 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson XP-301 Printing

1. Step 1: Prepare a Windows PC + USB cable and connect Epson XP-301 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-301 appears in the device list.
3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-301 to finalize.

Most Epson XP-301 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

Troubleshooting

• Temporarily disable VPN/proxy if validation fails.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

FAQ