Epson XP-100 Waste Ink Counter Reset

When the Epson XP-100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-100 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-100 Ink Pad Counter Warning?

Met Wic Reset Connect, you can reset the Epson XP-100 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typische tekenen

• ‘Bericht ’Service vereist' / levensduur van service in stuurprogramma of hulpprogramma
• Onderhouds-/supportcode (verschilt per model/driver)
• Afdrukken stopt na reinigingscycli
• Waarschuwing wordt herhaald na opnieuw opstarten van de printer

Reset Epson XP-100 Waste Ink Counter in 3 Steps

1. Stap 1: Connect Epson XP-100 to a Windows computer with a stable Internet connection using a USB cable.
2. Stap 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-100.
3. Stap 3: Plak de resettoets, klik op Reset, and after completion power-cycle Epson XP-100.

Most Epson XP-100 waste counter resets finish in ~1–2 minutes.

Systeemvereisten

• Geldige Wic Reset Verbind Resetsleutel
• Stabiele internetverbinding tijdens het resetten
• USB-verbinding vereist (Wi-Fi-reset niet ondersteund)
• Windows 7/8/10/11 PC

Veelgestelde vragen