Epson XP-100 Waste Ink Counter Reset

When the Epson XP-100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-100 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-100 Ink Pad Counter Warning?

Med Wic Reset Connect, you can reset the Epson XP-100 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typiske tegn

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Reset Epson XP-100 Waste Ink Counter in 3 Steps

1. Trin 1: Connect Epson XP-100 to a Windows computer with a stable Internet connection using a USB cable.
2. Trin 2: Åben Wic Reset Connect with admin privileges and verify device recognition for Epson XP-100.
3. Trin 3: Indsæt nulstillingsnøglen, klik på Nulstil, and after completion power-cycle Epson XP-100.

Most Epson XP-100 waste counter resets finish in ~1–2 minutes.

Systemkrav

• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Stabil internetforbindelse under nulstilling
• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Windows 7/8/10/11 PC

Ofte stillede spørgsmål