Epson NX410 Waste Ink Counter Reset

When the Epson NX410 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson NX410 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson NX410 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson NX410 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson NX410 Printing

1. Stap 1: Connect Epson NX410 to a Windows computer with a stable Internet connection using a USB cable.
2. Stap 2: Run Wic Reset Connect as Administrator and confirm Epson NX410 is detected.
3. Stap 3: Paste the reset key, click Reset, and after completion power-cycle Epson NX410.

Most Epson NX410 waste counter resets finish in ~1–2 minutes.

What You Need

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.

FAQ