Fix Epson L3278 Service Required – Waste Counter Reset

Epson L3278 Waste Ink Counter Reset

When the Epson L3278 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L3278 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson L3278 Waste Ink Counter

With Wic Reset Connect, you can reset the Epson L3278 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson L3278 Printing

  1. Stap 1: Prepare a Windows PC + USB cable and connect Epson L3278 directly. Keep Internet enabled for validation.
  2. Stap 2: Start Wic Reset Connect in Administrator mode and wait until Epson L3278 appears in the device list.
  3. Stap 3: Paste the reset key, click Reset, and after completion power-cycle Epson L3278.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructies

Most Epson L3278 waste counter resets finish in ~1–2 minutes.

What You Need

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson L3278 – Waste Ink Counter Reset using Wic Reset Connect.

Winkelwagen