Fix Epson ET-M1128 Service Required – Waste Counter Reset

Epson ET-M1128 Waste Ink Counter Reset

When the Epson ET-M1128 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-M1128 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson ET-M1128 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-M1128 waste counter reset in minutes.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson ET-M1128 Ink Pad Counter Reset – Quick Steps

  1. Stap 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-M1128 via USB (Wi-Fi reset is not supported).
  2. Stap 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-M1128.
  3. Stap 3: Use the key to reset the counter, wait for completion, then restart Epson ET-M1128 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructies

Most Epson ET-M1128 waste counter resets finish in ~1–2 minutes.

What You Need

  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson ET-M1128 – Waste Ink Counter Reset using Wic Reset Connect.

Winkelwagen