Model-specific reset guide
Canon TS9020 Ink Absorber Full Reset
Canon TS9020 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Understanding the Canon TS9020 ink absorber warning
The lock is based on accumulated maintenance activity. Resetting Canon TS9020 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon TS9020. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS9020
- Turn the printer off.
- Houd ingedrukt Stoppen/terugstellen.
- Terwijl u Stop/Reset ingedrukt houdt, houdt u Stroom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 keer.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS9020
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS9020 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS9020 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Connect Canon TS9020 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS9020 reset FAQ
Does Canon TS9020 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Hoe vaak moet ik op Stop/Reset drukken?
For Canon TS9020, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon TS9020
Wic Reset Connect combines a guided reset with support if Canon TS9020 does not respond as expected.