Model-specific reset guide
Canon TS5340 Ink Absorber Full Reset
If Canon TS5340 displays an ink absorber full or service-required warning, the stored waste ink counter may have reached its limit. This guide covers service mode, USB preparation and the reset itself.
Before resetting Canon TS5340
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS5340. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS5340
- Turn the printer off.
- Houd ingedrukt Stoppen/terugstellen.
- Terwijl u Stop/Reset ingedrukt houdt, houdt u Stroom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 keer.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS5340
The counter reset normally takes only a few minutes after Canon TS5340 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS5340 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS5340 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon TS5340 directly to the computer and try another data-capable USB cable or port.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TS5340 reset FAQ
Hoe vaak moet ik op Stop/Reset drukken?
For Canon TS5340, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon TS5340 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon TS5340
Wic Reset Connect combines a guided reset with support if Canon TS5340 does not respond as expected.