Model-specific reset guide
Canon MP190 Inktabsorber volledig resetten
Canon MP190 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
Why Canon MP190 reports an absorber error
Cleaning operations send unused ink into absorber pads inside the printer. Canon MP190 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon MP190. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP190
- Turn the printer off.
- Houd ingedrukt Stoppen/terugstellen.
- Terwijl u Stop/Reset ingedrukt houdt, houdt u Stroom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2 keer.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP190
Prepare Canon MP190 before entering the key. A stable service-mode state and direct USB connection are essential.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP190 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP190 is not detected
- Connect Canon MP190 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon MP190 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does Canon MP190 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Restore Canon MP190
Prepare Canon MP190, enter service mode and complete the reset with a valid Wic Reset Connect key.