Model-specific reset guide
Canon MG8250 Inktabsorber volledig resetten
An absorber warning on Canon MG8250 does not necessarily mean that the printer is mechanically damaged. The software counter and the physical pads must be considered separately.
Understanding the Canon MG8250 ink absorber warning
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon MG8250. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG8250
- Turn the printer off.
- Houd ingedrukt Stoppen/terugstellen.
- Terwijl u Stop/Reset ingedrukt houdt, houdt u Stroom.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 keer.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG8250
The counter reset normally takes only a few minutes after Canon MG8250 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG8250 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG8250 is not detected
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon MG8250 directly to the computer and try another data-capable USB cable or port.
Canon MG8250 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon MG8250
Ready to reset Canon MG8250? Verify the power light, USB connection and service-mode state before continuing.