Model-specific reset guide
Canon MP493 Ink Absorber Full Reset
Canon MP493 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
The waste ink counter inside Canon MP493
The lock is based on accumulated maintenance activity. Resetting Canon MP493 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon MP493. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MP493
- Turn the printer off.
- を押し続ける ストップ/リセット.
- ストップ/リセットを押しながら、 を押し続けます。 パワー.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 2 times.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MP493
The counter reset normally takes only a few minutes after Canon MP493 has entered service mode successfully.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MP493 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MP493 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon MP493 directly to the computer and try another data-capable USB cable or port.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon MP493 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
ストップ/リセットを何回押せばいいですか？
For Canon MP493, use 2 Stop/Reset presses in the sequence shown on this page.
Restore Canon MP493
Wic Reset Connect combines a guided reset with support if Canon MP493 does not respond as expected.