Reset Epson ET-2716 Waste Ink Counter in Minutes

Epson ET-2716 Waste Ink Counter Reset

When the Epson ET-2716 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-2716 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson ET-2716 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2716 waste counter reset in minutes.

How the Error Appears

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson ET-2716 Printing

  1. 1. lépés: Prepare a Windows PC + USB cable and connect Epson ET-2716 directly. Keep Internet enabled for validation.
  2. 2. lépés: Run Wic Reset Connect as Administrator and confirm Epson ET-2716 is detected.
  3. 3. lépés: Use the key to reset the counter, wait for completion, then restart Epson ET-2716 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Utasítás

Most Epson ET-2716 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson ET-2716 – Waste Ink Counter Reset using Wic Reset Connect.

Bevásárlókocsi