特定型号重置指南
Epson ET-2716 Reset Waste Ink Counter
Epson ET-2716 records cleaning cycles and waste ink usage in an internal counter. When that value reaches its programmed limit, printing can stop until the counter is reset.
Why the ink pad counter blocks Epson ET-2716
Waste ink produced by cleaning cycles is collected inside the printer. Epson ET-2716 tracks those cycles electronically and can stop printing when the calculated limit is reached.
Wic Reset Connect 旨在重置兼容的计数器 Epson ET-2716. 。必要时仍应检查并维护实体废墨系统。.
Reset the counter in Epson ET-2716
正确的准备工作可以避免在通信失败时使用重置密钥。选择“重置”前，请确认每项要求。.
-
安装原始驱动程序
Install the official Epson driver for ET-2716 and confirm that Windows can see the printer.
-
通过 USB 直接连接
Connect Epson ET-2716 to the computer without Wi-Fi, a hub or an adapter.
-
启动 Wic Reset Connect
Close Epson Status Monitor, run Wic Reset Connect as Administrator and select Epson ET-2716.
-
输入密钥并重置
输入已购买的密钥，选择“重置”，并保持打印机连接状态，直到操作完成。.
If Epson ET-2716 is not detected
- 将打印机直接连接到计算机。不要使用 Wi-Fi、USB 集线器、扩展坞或打印服务器。.
- 清除暂停的打印任务；如果其他程序占用了 USB 连接，请同时重新启动打印机和 Windows。.
- 如果未检测到打印机，请尝试其他 USB 端口和已知支持数据传输的 USB 线缆。.
- Install the original Epson driver for ET-2716; a generic Windows driver may not expose the required communication interface.
Epson ET-2716 reset FAQ
重置需要多长时间？
打印机被正确检测到后，重置本身通常会在约 1–2 分钟内完成。.
Does Epson ET-2716 need service mode?
不需要。Epson 打印机不使用 Canon 服务模式操作顺序。通过 USB 正常连接打印机即可。.
Can I reset Epson ET-2716 over Wi-Fi?
不能。Wic Reset Connect 需要通过 USB 直接连接到 Windows 计算机。.