Model-specific reset guide
Canon TR8580 Ink Absorber Full Reset
Canon TR8580 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What the Canon TR8580 service message means
Cleaning operations send unused ink into absorber pads inside the printer. Canon TR8580 estimates their usage with an electronic counter and can lock printing when that value reaches its limit.
Wic Reset Connect is designed to reset the compatible counter in Canon TR8580. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TR8580
- Turn the printer off.
- Nyomja meg és tartsa lenyomva Megállítás/visszaállítás.
- Miközben lenyomva tartja a Stop/Reset gombot, nyomja meg és tartsa lenyomva Teljesítmény.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 alkalommal.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TR8580
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TR8580 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TR8580 is not detected
- Connect Canon TR8580 directly to the computer and try another data-capable USB cable or port.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon TR8580 reset FAQ
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Does Canon TR8580 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
Hányszor kell megnyomni a Stop/Reset gombot?
For Canon TR8580, use 5 Stop/Reset presses in the sequence shown on this page.
Restore Canon TR8580
Ready to reset Canon TR8580? Verify the power light, USB connection and service-mode state before continuing.