Epson L1118 Waste Ink Counter Reset

When the Epson L1118 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L1118 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L1118 Stops Printing (Waste Counter Limit)

Posjet servisu je često nepotrebno. Wic Reset Connect allows a safe Epson L1118 waste counter reset in minutes.

Kako se pogreška prikazuje

• ‘Potreban servis’ / poruka o vijeku trajanja u upravljačkom programu ili korisničkom sučelju
• Kôd za održavanje/podršku (razlikuje se ovisno o modelu/vozaču)
• Tiskanje se zaustavlja nakon ciklusa čišćenja
• Upozorenje se ponavlja nakon ponovnog pokretanja pisača

Three Steps to Restore Epson L1118 Printing

1. Korak 1: Use a Windows PC (7–11) with Internet access. Connect Epson L1118 via USB (Wi-Fi reset is not supported).
2. Korak 2: Trči Wic Reset Connect as Administrator and confirm Epson L1118 is detected.
3. Korak 3: Unesite svoj ključ za resetiranje i pritisnite Ponovno pokretanje. Wait ~1–2 minutes, then restart Epson L1118.

Most Epson L1118 waste counter resets finish in ~1–2 minutes.

Uobičajena rješenja

• Zatvorite Epson Status Monitor ili druge uslužne programe za pisač.
• Ponovno pokrenite pisač i računalo, zatim pokušajte ponovno.
• Privremeno onemogućite VPN/proxy ako provjera ne uspije.
• Pokrenite aplikaciju kao administrator.
• Koristite izravno USB-povezivanje (izbjegavajte USB-hubove).