Epson L1118 Waste Ink Counter Reset

When the Epson L1118 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L1118 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson L1118 Stops Printing (Waste Counter Limit)

Et servicebesøg er ofte unødvendigt. Wic Reset Connect allows a safe Epson L1118 waste counter reset in minutes.

Hvordan fejlen opstår

• ‘Service påkrævet’/meddelelse om levetid i driver eller hjælpeprogram
• Vedligeholdelses-/supportkode (varierer efter model/driver)
• Udskrivning stopper efter rengøringscyklusser
• Advarslen gentages efter genstart af printeren

Three Steps to Restore Epson L1118 Printing

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson L1118 via USB (Wi-Fi reset is not supported).
2. Trin 2: Løb Wic Reset Connect as Administrator and confirm Epson L1118 is detected.
3. Trin 3: Indtast din nulstillingsnøgle, og tryk på Nulstil. Wait ~1–2 minutes, then restart Epson L1118.

Most Epson L1118 waste counter resets finish in ~1–2 minutes.

Almindelige rettelser

• Luk Epson Status Monitor eller andre printerværktøjer.
• Genstart printeren og pc'en, og prøv igen.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Kør appen som administrator.
• Brug en direkte USB-forbindelse (undgå hubs).