Epson WorkForce 600 Waste Ink Counter Reset

When the Epson WorkForce 600 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson WorkForce 600 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson WorkForce 600 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WorkForce 600 waste counter reset in minutes.

Common Symptoms

Printer refuses to print even with ink available
Epson Status Monitor shows maintenance warning
Blinking lights and blocked jobs
Device is locked until reset is performed

Three Steps to Restore Epson WorkForce 600 Printing

Paso 1: Prepare a Windows PC + USB cable and connect Epson WorkForce 600 directly. Keep Internet enabled for validation.
Paso 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WorkForce 600.
Paso 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WorkForce 600.

Buy Reset Key ⬇️ Download Wic Reset Connect Instrucciones

Most Epson WorkForce 600 waste counter resets finish in ~1–2 minutes.

System Requirements

Stable Internet connection during reset
Valid Wic Reset Connect reset key
Windows 7/8/10/11 PC
USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

How long does it take?

Usually about 1–2 minutes.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson WorkForce 600 – Waste Ink Counter Reset using Wic Reset Connect.