Reset Epson NX220 Waste Ink Counter in Minutes

Epson NX220 Waste Ink Counter Reset

The Epson NX220 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson NX220 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson NX220 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson NX220 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

Printer refuses to print even with ink available
Epson Status Monitor shows maintenance warning
Blinking lights and blocked jobs
Device is locked until reset is performed

Step-by-Step: Epson NX220 Waste Counter Reset

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson NX220 via USB (Wi-Fi reset is not supported).
Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson NX220.
Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson NX220.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson NX220 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

Try another USB cable (some cables are charge-only).
Restart printer and PC, then try again.
Use a direct USB connection (avoid hubs).
Temporarily disable VPN/proxy if validation fails.
Run the app as Administrator.

FAQ

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

How long does it take?

Usually about 1–2 minutes.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson NX220 – Waste Ink Counter Reset using Wic Reset Connect.