Epson L558 Waste Ink Counter Reset

When the Epson L558 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson L558 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson L558 Show ‘Service Required’?

Most Epson L558 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson L558 Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson L558 via USB (Wi-Fi reset is not supported).
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L558.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L558.

Most Epson L558 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Restart printer and PC, then try again.