Canon TR8530 Ink Absorber Full Reset

If your Canon TR8530 suddenly refuses to print and shows a maintenance or service warning, the ink absorber counter may have reached its limit.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TR8530. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

• Service / maintenance warning on the screen or driver
• Printer refuses to print even with ink available
• Blinking lights and queued jobs fail
• Error reappears after restart

How to Enter Service Mode on Canon TR8530

If your Canon TR8530 supports service mode reset, follow the steps below before performing the counter reset.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Reset the Ink Absorber Counter

Once the counter is cleared, Canon TR8530 should exit the locked state and printing should resume normally.

Before You Continue

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

If your model does not show a service mode section, it means no matching procedure was found for its series.

Common Fixes

• Use the correct Stop/Reset press count for your series.
• Try a different USB cable/port if using PC software.
• Close other Canon printer utilities while resetting.
• Power-cycle the printer and try again.
• Repeat the service mode steps carefully (timing matters).

FAQ