Canon TR160 Ink Absorber Full Reset

Canon TR160 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon TR160. Service mode instructions are shown only when a matching series procedure is known.

What You May Notice

• ‘Ink Absorber Full’ / ‘Service Required’ message
• Support/service code (varies by series)
• Printing blocked after cleaning cycles
• Reset required to continue printing

How to Enter Service Mode on Canon TR160

To access maintenance functions, Canon TR160 may need to be placed in service mode first.

1. Turn the printer OFF.
2. Press and hold Stop/Reset.
3. While holding Stop/Reset, press and hold Power.
4. Release Stop/Reset (keep holding Power).
5. Press Stop/Reset 5 times.
6. Release Power — the printer should enter service mode.

If it doesn’t work, repeat the sequence carefully. The press count depends on the series.

Perform the Waste Ink Counter Reset

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Warnings

If absorber pads are truly saturated, ignoring maintenance can lead to ink leakage inside the printer. The counter reset only removes the software lock.

Download & get started

Use a reliable USB connection and follow the steps in order.

Troubleshooting

• Use the correct Stop/Reset press count for your series.
• Close other Canon printer utilities while resetting.
• Repeat the service mode steps carefully (timing matters).
• Power-cycle the printer and try again.
• Try a different USB cable/port if using PC software.

Frequently Asked Questions